davbucci ,
@davbucci@mastodon.sdf.org avatar

@foone A trick that I used back in that time (UV sensitized boards were too expensive for me) is to photocopy on ordinary paper the circuit, then put it on top of a bare copper clad board, use a nail to gently mark the position of each hole through the paper, use a pen to trace manually the tracks by copying the best I could the tracks and finally etch the board and drill the holes. You save the UV transfer project, but it quite error prone and slow.

  • Alle
  • Abonniert
  • Moderiert
  • Favoriten
  • random
  • haupteingang
  • Alle Magazine